起重机试验规范和程序（英文版）
英文名称： Cranes－Test code and procedures
中标分类： 机械>>通用机械与设备>>J80起重机械
ICS分类： 材料储运设备>>起重设备>>53.020.20起重机
UDC分类： 621.873.877
采标情况： ISO 4310-1981
发布部门： 国家标准局
发布日期： 2000-01-01
实施日期： 2000-01-01
首发日期： 1986-03-03
复审日期： 2004-10-14
归口单位： 北京起重运输机械研究所
主管部门： 中国机械工业联合会
起草单位： 上海起重运输机械厂
页数： 平装16开， 页数：7， 字数：8千字
本标准规定了检验起重机是否符合其工作性能参数和技术要求以及是否能够升额定载荷所应准循的试验及程序。
对额定载荷取决于稳定性的起重机，还规定了用于检验稳定性的试验程序和试验载荷。
目录
1、适用范围
2、试验种类和样机的数量
3、试验程序
4、试验条件
1. Scope and Field of Application
This standard specifies the tests and procedures to be followed in order to verify that a crane conforms to its operational specifications and is capable of lifting rated loads. Where rated loads are governed by stability, a test procedure and test load are specified that permit stability margins to be easily verified.
This standard is applicable to the following crane types:
a. Bridge cranes;
b. Bridge and portal cranes;
c. Portal cranes;
d. Mobile cranes;
e. Tower cranes;
f. Railway cranes;
g. Cable cranes;
h. Others applicable to this standard.
2. Types of Test Procedure and Number of Samples
2.1 Three types of test procedure are to be used to accomplish the aims of this standard:
a. Testing of cranes for conformity to specifications as set forth in 3.1;
b. Visual inspection as set forth in 3.2;
c. Load lifting competence testing as set forth in 3.3.
2.2 All cranes shall satisfy the test procedures specified above; however, in the case of serially manufactured cranes, the sample number of cranes to be tested under a and c should be determined by buyer and supplier1) (In legal terms, the user and supplier are understood to be the parties who have entered into the contract. The supplier is the party supplying the crane and the user is the party who uses the crane according to the contract) through mutual agreement.
2.3 Cranes which leave the manufacturing factories ready for service shall be tested in these factories prior to delivery; cranes which are mounted or finally assembled at their places of use shall be tested at these places unless other agreements between the user and supplier are reached.
No comments:
Post a Comment